Buy Now Fluke I30 AC/DC Current Clamp
Specified current range 30 mA to 30A dc, 30 mA to 20 A ac rms Usable current range 5 mA to 30 A dc, 30 mA to 20 A ac rms Fluke I30 I 30 AC DC Current Clamp Meter The i30 current clamp is based on Hall Effect technology to use in measurement of both DC and AC current. The i30 may be used in combination with recorders, multimeters, or other suitable instruments for accurate non intrusive current measurement. Electrical specifications Specified current range 30 mA to 30A dc, 30 mA to 20 A ac rms Usable current range 5 mA to 30 A dc, 30 mA to 20 A ac rms Crest Factor 1.4 inches Output sensitivity 100 mV/A Accuracy (at +25 °C) ± 1 percent of reading ± 2 mA Resolution ± 1 mA Load impedance > 10 k Ohms and ? 100pF Conductor position sensitivity ± 1 percent relative to center reading Frequency range DC to 20 kHz (- 0.5 dB) Temperature coefficient ± 0.01 percent of reading/degrees Centigrade Power supply 9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator Working voltage (see Safety Standards section) 300 V ac rms or dc General Specifications Maximum conductor size 19 millimeter diameter Output connection 4 millimeter safety connector Output zero Manual adjust via thumbwheel Cable length 1.5 meters operating temperature range 0 to +50 degrees Centigrade Storage temperature range (with battery removed) -20 to +85 degrees Centigrade Operating humidity 15 to 85 percent (non-condensing) Weight 250 g Safety standards BS EN 61010-1:2001 BS EN 61010-2-032:2002 BS EN 61010-031:2002 300 Vrms, Category III, Pollution Degree 2 Use of the probe on uninsulated conductors is limited to 300 V ac ms or dc and frequencies below 1 kHz. EMC Standards EN 61326: 1998 +A1, A2, & A3 Output sensitivity 100 mV/A Based on Hall Effect technology DC range: 30 mA to 30 A AC range: 30 mA to 20 A rms Used in conjunction with multimeters, recorders 1 Year warranty
Visit: Cheapest NewAir G73 Electric Garage Heater With Built-In Thermostat
ไม่มีความคิดเห็น:
แสดงความคิดเห็น